News of x-sim

Hello everybody my name's Dmitry and yes, I'm Russian.
I'm a complete beginner here and I have problems with communication language, I expect your possible support with things I encountered with when I first touched upon the subject of motion simulator games.
There’re several issues at hand I’d very like to have a full answer to, so please, don't be mad on my English.
1. Where can I get the software (games) for the simulator? ...

Hello everybody my name's Dmitry and yes, I'm Russian.
Since I'm a complete beginner here and I have problems with communication language, I expect your possible support with things I encountered with when I first touched upon the subject of motion simulator games.
There’re several issues at hand I’d very like to have a full answer to, so please, don't be mad on my English.

1. Where can I get the software (games) for the ...

Well after quite a bit of reading on here I've started my own platform motion sim rig.

I have decided to try and emulate Floriske's GT playseat. I will build using the same general layout for base and platform but intend to make a few slight mods. I will directly gear the feedback via some sort of clutch mech. I'm gonna use gas struts half loaded at a centralised platform rest position, secured centrally at ...

(Text written by WarAndPeace, imported from the x-sim.de aluminum forum)
Hier wird gezeigt, wie der Wooden Simforce GT von WarAndPeace, meiner Wenigkeit und Ingo sowie Markus gebaut wurde. Wie man sieht, haben wir für das Gestell nur handelsübliches Holz aus dem Baumarkt verwendet. Winkel und Schrauben haben wir ebenfalls aus dem Baumarkt bezogen. Als Werkzeug diente ein Akkuschrauber, Bohrmaschine, Bügelsäge sowie eine Feile und Schmirgelpapier.

In this project you can see how the Wooden ...

Since I'm most likely not the only newbie trying to figure out motion profiles ;) I decided to place this discussion here rather than in my project topic.

At the start of this discussion I had the following values in my race07 profile in progress:

• Vertical force: 1500000 @ 40%
• Lateral Force: 2000000 @ 70%
• Longtitudal Force: 2000000 @ 60%

Those values where set during ...

After a request by Sirnoname I've been working on a simple project gallery page:

It is listed in the main menu, on the portal page and the side menu of the software page and it:

• list all projects in the "projects in progress" forum with the start date and last post date (with links) sorted by last post date so active topics are always shown first.
• Search for the first attached or included ...

Hi my name is Adam and I'm from Australia, I'm an instrument technician by trade and am very interested in building my own rig. I have done research and think i would like to go with a boat winch or worm drive motor as the SCN5 actuator seems very jerky and expensive in comparison. I would love to be able to do this for less than 600$

I have been doing some sketches with my ...

wooow, it looks grate! what program are you using to draw the prototype

best regards fer



Esta muy chida tu idea compadre! con que programa lo estas dibujando

fer

Greetings, :D
I would like to see profiles and plugins for FS2004 & FSX!
jsmith2307

If this existed we'd be using it. But since I don't see many posts about it I assume it doesn't.

Any affordable frequency inverters out there, preferably with vector control...?

hey speedy! You mentioned recently you'll be using 0.5hp 3-phase units with inverters that take 120V single-phase and output 3-phase 220V. Can you tell us more about it?

The power supply is free, and AC technology is superior (IMHO) in many ways. But there's a ...