News of x-sim

Bonjour à tous
Cela fait pas mal de temps que j' utilise xsim sur mon simu 2dof, je me suis rendu compte il a pas très longtemps que dans les jeux ams, assetto, rfactor2 je n'avais pas le même ressenti au niveau du volant ( ffb et angle de rotation), quand les jeux étaient lancé avec ou sans xsim. J'avais mis ca sur le compte du simu, quand il bouge on est moins concentré sur ...

hi
my name is Edward
I like playing with electronics and stumbled upon this amazing site.
I live in south Africa
using a E36 dash. Arduino for running the cluster with xsim

anything else please ask :)

Hello,

thank you for the Help in this Forum and the great X-sim Software.
I use it for 2 Bass shakers. Increases the immersion alot in VR.
Try it.

Greetings

Hi, I have this error,

Found SCN5 actuatot but emergency stop (ILK pin) was executed
The actuator wil be ignored until ILK pin is tied to 24 again

My adapter ;http://sinforcon.com/product/html/347.html
My actuators SCN5 -010-150-s03
S/N9C 931 KR

Bought in korea MADE IN JAPAN

First I made, the connections as they are in the diagram, with the resistance and the diode

and then

I connected the gray wire (pin 8), to 2V without resistance, and ...

Hello,
I have a very strange problem, I used motomonster but I did not get a good result and I bought ibt-2, the problem is that I have a return current of the motors, in the sudden changes the voltage rises, but if you leave the limits of smc3 Turns a turn and I get up to 19V, this causes me to burn 12v fans.
The ibt2 have no protection for this?

Buonasera a tutti !!!
Sono Nuovo e vorrei costruire un 2dof ... Chiedero consigli a tutti voi!!!

Ciao

Guys, i need help.

Everything is connected and working in tests using arduino app 1.8.2 (i did my own code), i can move both motors , read de pot ...

BUT

when i use the XPID 1.4 and do the tests in X-SIM , i just get one motor working (already check the pins in code, thats all ok )

Im wondering if some dll is wrong ..

I read all forum, tried a lot ...

Hello,
I can not establish a connection between the simulator and the xsim program I have done.
There is something I want to learn. I am writing "non commerical devices not allowed" in the top right corner of the converter and extractor programs. My computer is a personal account, not for multiple uses. This article is not loading the program load. Is this the one that prevents me from connecting the Xsim software to the ...

Hi everyone,

I'm trying to use the CKAS 6DOF Platform from my university, but impossible to connect it to my computer.

I've tried to reboot everything twice, but it didn't seem to work. My computer detecs correctly the platform as an external hardware and says the driver is correctly installed. But when I try to launch SimCore to calibrate the simulator it says 'No Motion System detected' and shuts down.

Does anybody already had this ...

Arduino code for dynamic playseat 2DOF
*/

#define BRAKEVCC 0
#define RV 2 //beware it's depending on your hardware wiring
#define FW 1 //beware it's depending on your hardware wiring
#define STOP 0
#define BRAKEGND 3

////////////////////////////////////////////////////////////////////////////////
#define pwmMax 255 // or less, if you want to lower the maximum motor's speed

// defining the range of potentiometer's rotation
const int potMini=208;
const int potMaxi=815;

////////////////////////////////////////////////////////////////////////////////
#define motLeft 0
#define motRight 1
#define potL A0 ...