News of Controllers and Drivers

Hallo,

I have the kangaroo v2 hooked up on a sabertooth. Connected via USB ttl adapter. 3 diverent Versions. Xsim does Not recognize the kangaroo as input. The velleman without problems. Describe Software finds the kangaroo. What's going wrong? Here In the forum its said the 5V pin of the kangaroo should be Connected with the ttl adapter? I only have ground, S1 and S2. Need some help.
Danny

To control my Joyrider driven by two wiper motor which the best and easier way to do that? Do you recommend pololu interface ?

Which one exactly and where to get?

Thank for your support
Best regards
Shaker

Hello everyone, I have been fighting vs this program for a few weeks and I have not been able to do anything and I can not find information to help me, is the Cinema motion editor, I made some roller coasters in unreal engine very funny and I want to be able to enjoy them With movement but i cant connect xsim and unreal because I consider it very complex to program the time line ...

Can anyone help me out with a working code for the Arduino uno & Sabertooth 2x32?, i was going to bulid a 2dof seat mover, but got carried away and bulit a 2dof full frame simulator.............will upload pic's soon, but, just can't seem to find a code that will get the arduino & sabertooth working together. Thanks in advance for any help.

Are their any Pihidget interface plugins for X-Sim or is there a possibility of these being being developed? Tx.

Good evening friends, I have some doubts on the PWM outputs of Arduino Uno (ATMEGA328P).

I want to use an H-bridge driver for DC motors, but I prefer to create a new bridge with my hands (IBT-2 is not reliable)
So I necessarily need to know the PWM mode of operation.

In the case the attached diagram, Arduino drives two H bridges through the pin and 2-3-9 05/04/10
Ok, and up there no problem ... ...

Good evening friends, I have some doubts on the PWM outputs of Arduino Uno (ATMEGA328P).

I want to use an H-bridge driver for DC motors, but I prefer to create a new bridge with my hands (IBT-2 is not reliable)
So I necessarily need to know the PWM mode of operation.

In the case the attached diagram, Arduino drives two H bridges through the pin and 2-3-9 and 4-5-10
Ok, and up there no problem ...

Hi all,
I'd like to use step motors, like this as example:
http://www.rta.it/en/category/2312-stepping-motors

I'm trying to figure out what kind of logic board I have to use to pilot that kind of motors with X-SIM.

thank a lot

Hello everyone :roll:
I need a step by step guide of communication of Arduino with X-SIM

Just tell me how can i send game data from converter to any of arduino pin........


I have arduio mega and installed x-sim and interfaced games with that.


Thanks in advance

Built these years ago and already back then verified their basic functions without motors. Just recently decided to revive this project and continued where i left off.

Everything still seems to work as planned; direction indicator LEDs following pot rotation and LCD display showing numeric values and multimeter hooked up to either output i get -12,7V...12,7V on both motor outputs. But when i hook up actual wiper motors results change and are not so good. ...