News of Converter questions

I am absolutely new here and would like me a Racing Seat with 2 Bewegachsen (for brake / gas power and for the sides force simulation) The whole thing should run on RBR. Have me with the program already set several days apart and I'm already getting few steps further. Unfortunately, I can not do it to get an output signal on the interface board it. Manual can I set inputs and outputs. Thus, the ...

Hi all,

I am writing a code for an Arduino Uno wich will drive 4 motors (maybe 6 later) using 2 sabertooth in serial mode.

I would like understand what I need to write in my "Datapacket with axis informations" shield :
- I chose 8 bit resolution and dezimal output.
- I named my axis with A, B, C and D

If I want a checksum only for data from axis (I don't need ...

Hey all

I have the problem that when i try to start the X-sim Converter, my PC asks for permission, thinks for a second and then stops thinking without anything popping up.

When i go to the joblist under the tab processes, i can see the program running.

I've tried to start it with compatabillity with Windows 7 but doesn't work.

Please help

Postsol

I originally had the settings to:
3ms
3ms
100ms

And I got always 166 outputs after a scan of scn5serial



Recentley I changed it to:

0ms
0ms
100ms

And I got 250 outputs/second after hardware scan constantly! Is this setting okay to keep?

how do i change udp port in xsim software? thanks

Hi guys, i've just bought a renovatio srd9 c display, and the srd manager installed all the plugins for me...now to make it work the manager adds this line in the hardware_settings_config file for example in codemasters titles: <motion enabled="true" extradata="2" delay="2" port="27077" ip="127.0.0.1"/>

Problem is that this ovverride this line: <motion enabled="true" extradata="1" delay="1" port="20777" ip="127.0.0.1"/>

wich is the one needed for motion output, so i can get the display or the seat working ...

Someone knows why when i add vertical force, longitudinal and lateral forces stop working?, i have my simulator almost done, but this is going me crazy.
i will apreciate your help guys.

Hi guys, I have an issue when I quit the game. Basically, when I quit the game the Converter just go crazy, and he show me a thousand of error "no game connection" and says something like "No game connections avaiable, please check network communication and press start". I use the autostart trigger, and it's load the profile automatically with no problems, but it goes crazy when I exit. Since now I always closed the ...

hi guys, is there any way to change a setting, so that i can have less travel wile braking and more wile accelerating? thanks

Good night to all.



I'm looking to use the X-SIM software without success



Every time that I open the program appears a message that says



Found SCN5 Actuator, but emergency stop (ILK pin) was executed.

The actuator will ignored until ILK pin is tied to 24 V again.



I've tried to attach that ILK Pin (pin 8) directly to the power supply (24V) just to check if the system works but it not.



I Know ...