News of General Chat

Hey,

I was just thinking that would it be possible to make low-prized dd-wheel form wiper-motor ?
Using data from X-sim would be great way to do it..

I am not to familiar with these motors, so I thought I just would start a discussion 8)

As a newest member of X-Sim I'm planning to finish my static Sim project first. I have 2 step plan for my Project and I will go on when I have enough sources and knowledge.

1st Step : I will use 48 inch led tv, 5+1 Logitech Z5500 , Logitech G25 or G27 , Office type racing seat , height adjustable table for Whell set with a pedal handler. All i need is to buy ...

Hello first of all my name is mike. I have just discovered this software and am using it to display gauges on my laptop. I have a Triple screen display and mostly race on iracing.

On the extractor I have iracing seleted with the profile

On the converter I have the gauge profile dastardly_dashboard. And the rpm and speed works flawlessly but not the pos or the lap or well anything else. So just wondering ...

Hi all,

Very new to the whole motion simulator area but as a newbie I would like to start small and go from there.
The question is if I go for e.g. a 2DOF sim in the beginning, can the equipment be reused later for e.g. a 6DOF setup?
If not would it be too much for a newbie to start for a 6DOF sim rather than a 2DOF.
E.g. starting with a model 6DOF ...

Hey guys.

I have a question, is it possible to have x-sim move my motion platform according to joystick movement and button presses WHILE playing a game?

I know this is far from ideal but I've been thinking about it and in Star Citizen since there is no gravity and no atmospheric "lift" I think it will be a lot better than no motion for me until extracting data from the game becomes possible (which ...

I'm following RacingMat's excellent guide to build my 2DOF sim but have a problem with getting the motors.

The motors he recommends cost 62,18€ for two of them but then an additional 82,00€ for shipping to the US!
That is total 144,18€ for the two motors!

I found someone else asking and these were recommended for in the US http://www.ebay.com/itm/GEAR-MOTOR-12-V ... 564a80e961
But these will cost me total equivalent ...

Hey guys, I've finally started working on my project and despite lots of reading was left with some questions. I read the "Why use scn5 linear actuators?" thread and despite wanting to keep the cost of my project to a minimum it made me tempted to put a pair of SCN5 actuators on a credit card.

My biggest question is in all, with everything included how much cost difference would you estimate between using two ...

Hi!

I'm new here, so please bear with me :)
At home I have set up a gaming rig and a sound-studio combined.. I am using an external soundcard + pre-amp for recording and stuff...

I have ordered a ButtKicker and it's on its way. But all the tutorials have confused me.. How can I dedicate my external soundcard to X-Sim, and at the same time hear ...

Hello everyone,sorry for my english, I made this f1 simulator, I wanted to know if you can do something to make it dynamic.

Hi, can someone help me to configure pneumatic pistons with velleman? (wire scheme and software) Thanks to all ;)