News of x-sim

Good morning to all, I connected my version of the AMC1.6 at simulation soft (X-sim vers. 2) and firmware resets constantly when runs the simulations. I´m using rFactor and Sender & Profiler was configured using 2 Axis.

I am using the latest firmware ---> FTISP for AMC1.6 1.1e.zip "Added 10% dead zone on end positions of POT (25/Jul/2012)"

When runs the simulations and prifiler sends data by USB to AMC positioning movement begins engines with ...

Has someone such a device?

http://gamatronix.com/product_info.php/products_id/28

12V 3A seems to be usable for wiper engines.

Hi there

Can anyone tell me what is a acceptable duty cycle for a electric linear actuator in a sim? :?:

hi guys first im new to this apart from reading . i have a few questions hopefully someone will answer. im hoping to build a 3dof platform

1st i plan on using the JRK12v12 x 3 what is the wiring process of these is it pc via usb + power supply >JRK12v12 >pot and motor
if so what steps can be taken to prevent any damage to the JRK12v12 or motor

what is the limitation ...

Hi i am in the intial starting blocks of building joyrider and was looking at arduino r3 and motor shield to run wiper motors, i have very very limited pcb build knowledge so looking for something that not to expensive to do the electronics .

Mechanics i have under control but need help if anyone got arduino working with xsim and the like

Much appricate any help

( btw first post so bare with me ...

Hi,

First of all i'm new here so pardon me with all the noob questions i might ask.

I'm trying to pull data for rpm, gear and speed for need for speed: Underground 2.
I've manage to find the rpm but ended up with 2 address. Also I've found the gear address but it's in String instead of bytes so does that matters? Also i cant seems to find the speed. All of the above ...

Hi all!

FINISHED: PAGE 8



I wanted to show my first project here, it will be 2DOF with 2 big motors (from Floriske :D ) driven by 2 Pololu's 12V12 and offcourse X-Sim. :)

I'm a beginner in the sim world, so i'm very happy to see this forum with projects and people to help me ...

While reading the JRK 12V12 user manual I noticed that firmware 1.4 has been released on august 15th 2012.

Might just be interesting news for the JRK users overhere:

http://www.pololu.com/docs/0J38/3.h

as far as i understood, to have your sim running you need

1. control board
2. h-bridge to control motors (or actuators or etc)

control boards are a little expensive... the question is... can you replace the control board (let's say welleman or the tronic amc card) with a cheap arduino card?

could it be done? or arduino is just usless.

i ask this question because last days i have been some arduino cards and ...

Hereby I would like to bring a few users some good news:

---

The following users have earned themselves a stage 2 key with their project logs! Congratulations!

• Jsmith2307 for: viewtopic.php?f=37&t=280
• Kevin123 for: viewtopic.php?f=37&t=133
• Spartan300 for: viewtopic.php?f=37&t=279
• txus for: viewtopic.php?f=37&t=252
• bruceaust for: ...