News of Controllers and Drivers

Hi,

ive got a short question.

Does anyone have experiences with the BB-VNH3SP30?

I'm looking for affordable HBridges for my 2DOF Vipermotor Arduino Playseat Project.

Do not get me wrong the only thing i have so far is my arduino Leonardo ;-)

So im estimate the cost of my little dream :D

i hope my english makes sense ...

hi gents,
I keep getting alot of disconnects while running my 2DOF racing sim.
at times it works for an entire race, but most of the times it disconnects or crashes the Converter several times during a race. of course, this makes it unusable.

I'm running Windows 7 64bit system and tested with another PC and a laptop via network and the behavior is the same. I use an USB hub between the JRKs and ...

As the title suggests, this card is compatible with x-sim?

My new project involves 4 engines, and I had thought of this Vm140 what do you think?

Or K8055 2, and 2 sabertooth, and possible?

Thank you

Hi,
My Name is Martin and i´m new here.
Very slowly i can manage all the impressions out of this site. It is my first time using a Thing like an arduino, so i hope you can help me

Last week i bought an ardui´no and the following hbridge:
http://www.ebay.at/itm/1xArduino-Smart- ... 3cc50e778f

I alos bought some wipers like this:
http://www.amazon.de/ATEC-Wischermotor- ... chermotore


Can ...

Hi guys,

I received an arduino uno and a monster moto shield for a new project. I will be using wiper motors. I just had a look at the shield and can't believe this thing has enough copper to handle any kind of current! Are you guys that are running them having any issues?

I will add heat sinks but it's the traces on the board that have me worried. I also wonder if any ...

Hi All

Link to new H bridge driver up to 30 amp, @ 36 volts

https://www.olimex.com/Products/RobotPa ... e-hardware

regards Terry

Kangaroo x 2 Position Control Module

The Kangaroo x2 is a recently introduced addition to the Dimension Engineering product
range to provide position control to the Sabertooth and Sysren range of DC brushed motor
controllers.

Kagaroo x2 Specifications
2 channel self tuning PID controller
Position or Speed Control
Potentiometer or Quadrature Encoder feedback
Support for limit switches or mechanical stops
Serial TTL input

Compatibility Dimension Engineering Brushed DC Motor Drivers
Sabertooth 2x10, 2x12, 2x25, 2x25V2, ...

I'm looking into re-starting my Simulator project.

I am looking at the polulu 12v12 but I am wondering if these can handle the amps itself or if I need a hbridge?

I was going to plug it up to 3 winch motors (1 polulu per motor) and car batteries..

Hey guys,I am trying to make my own simulator.I have the simulator built but i do not know how to wire the boards up. I will be using one pot and the bridge and uno board you see in the pictures. I am wondering if some one could tell me where to hook the wiring up to each other? I am using a wiper motor to run it,and it wil only lean left and right. ...

Hi, i've got two 12v12 jrks connected to two distinct wiper motors and two distinct power supplies, that function perfectly when plugged one at a time. But when i connect both of them to usb ports then strange things happen, infact if i give a manual input to one of them in the jrk config utility both motors run, at first the right one followed by the other motor that wasn't supposed to move and ...